|
|
Post by parmil on Apr 9, 2010 18:19:00 GMT -5
Ordered the basic interior wood trim kit for the vert. Looks real fragile and I'm sorta "ham handed". Anyone had any experience with putting one of these in? Has instructions but there's always something more that pops (bad choice of words!) up! Any hints appreciated.
|
|
|
|
Post by FlowRW on Apr 9, 2010 20:19:44 GMT -5
It goes on with that 3M double sided tape. Make VERY sure it's where you want it. It sticks on contact. Before installing, make sure there's no burrs or rough edges. A fine finger nail file or emory cloth works well.
|
|
|
|
Post by electricbluegt on Apr 9, 2010 22:46:26 GMT -5
Another little trick you can do is just peel off just enough of the wax paper from the 3M tape so you can grab the end of it while it's laying in the install location. Then place the piece where you want it and pull the paper out from under it. As long as the initial placement is where you want it you can get er stuck in the right place.
|
|
|
|
Post by tarheelcruiser on Apr 4, 2011 9:07:52 GMT -5
Yep once you put it down it is there. On bigger pieces cut the tape so the it comes off in smaller pieces. Dry fit FIRST and have a steady hand, it looks good when done if it is right to start with. I sure wouldn't want to do it for a living though. Too much concentration needed.
|
|
guess who